Thread: Discussion 3DHS Fanatics!
View Single Post
Old Mar 16, 2012, 10:04 PM
HugoCraft is offline
Find More Posts by HugoCraft
Aerobatic Fanatic
HugoCraft's Avatar
United States, KY, Louisville
Joined Sep 2007
2,910 Posts
I mistyped earlier that the axles are bigger than 3/16" diameter because the 3/16" collars don't fit them but have never looked for collars in any other place than a LHS. I had a 450 helicopter main shaft collar laying around and it slightly too small and its 5mm ID.

Once I get the right size collar I think I'll be good to go for the weekend. I think a flat spot for the set screw w/blue thread lock and green threadlock on the axle to collar will hold it really well. I don't mind changing it to something different afterward but still trying to figure out "goflyhighrc" earlier post about a DOT.
HugoCraft is offline Find More Posts by HugoCraft
Reply With Quote