View Single Post
Old Mar 16, 2012, 06:54 AM
grmis is offline
Find More Posts by grmis
Registered User
grmis's Avatar
France, IDF, 91
Joined May 2011
254 Posts
Setting failsafe on OrangeRX DSM receivers

Hi,
If one needs *all* channels to go to some specific positions on signal lost, one should bind the receiver in the following way:
- TX & RX off
- Plug the binding plug
- Switch on the RX -> flashes
- Remove the binding plug -> RX keeps flashing
- Switch on the TX in binding mode with the sticks at desired positions

This worked for me with(Dx6i) with the 6ch as well as with 9ch receiver from OrangeRx. I think it is the same procedure with most genuine spektrum receivers.
If you don't remove the plug before switching on the TX, only the throttle channel will move (to zero) in case of a signal loss ("Preset failsafe" mode, as mentioned above). Hope this helps!
grmis is offline Find More Posts by grmis
Last edited by grmis; Mar 16, 2012 at 06:56 AM. Reason: misprints
Reply With Quote