View Single Post
Old Mar 13, 2012, 10:40 AM
DoctorG is offline
Find More Posts by DoctorG
Registered User
DoctorG's Avatar
United Kingdom, Basingstoke
Joined Nov 2011
28 Posts
Graphics & Engines

I used ink jet printed vinyl for all my decals. Clear vinyl in this case. I have used it on many projects and it works very well. Allow the printing to dry for a couple of hours and then brush over Clearcoat and allow to dry for 24 hrs. Then cut from sheet. Fuel proof/varnish again once in place - type depending on how much fuel it gets. On the Falcon I used a matt water based 'floor' varnish. As noted in other parts of the thread Lasers run clean and mine has a socking great silicone pipe to take tthe exhuast out to the wheels. After 45 minutes of tootling around it lands as clean and dry as when it took off.

By the way what does it take to kill the Laser 70 vs Laser 62 argument? Mine flies most of the time on 1/4 throttle on the Laser 62. It is totally fine. You do not need a Laser 70 unless you are buying a new one. In that case look very hard at lots of down thrust and side thrust.
DoctorG is offline Find More Posts by DoctorG
Reply With Quote