Thread: Discussion Hobbyzone Champ Mods
View Single Post
Old Mar 13, 2012, 09:38 AM
Lancer31 is offline
Find More Posts by Lancer31
Registered User
Joined Jun 2005
3,785 Posts
Quote:
Originally Posted by totaldoughnut View Post
Thanks alot Lancer. I was actually checking out those micro boards on hobby king earlier. Seems like a pretty sweet setup and very affordable. Heck if I go that route then I can use my old champ board in my balsa rubber power conversion. Would it be possible to run 2s with those boards? Im still a noob to all this brushless stuff.
If you put a small UBEC in place to run the board, (7.4V in, 5V out to the micro board), with a resistor in series, to bring it down to 4.2V, that would work.
Lancer31 is offline Find More Posts by Lancer31
Reply With Quote