View Single Post
Old Mar 12, 2012, 12:23 PM
Rob Mackenzie is offline
Find More Posts by Rob Mackenzie
Registered User
Canada, AB, Olds
Joined Apr 2011
94 Posts
ExAIR asked "On the template overlay view, could you possibly scale up the wing until the angles all intersect foamboard edges, and then advise the measurements from the corners of the foamboard to the necessary fold lines and cutlines? I'm just thinking some cavemen like me might be able to more easily trace the outline without an actual template or protractor. "

This isn't exactly what he had in mind but it is as close as dammit is to swearing... and it does (almost) fit in this orientation on a 20x30 foamboard sheet.

Click to enlarge thumbnail:
Rob Mackenzie is offline Find More Posts by Rob Mackenzie
Last edited by Rob Mackenzie; Mar 19, 2012 at 08:28 PM. Reason: better fit
Reply With Quote