View Single Post
Old Mar 10, 2012, 11:00 PM
Username> is offline
Find More Posts by Username>
Suspended Account
Joined Dec 2007
1,103 Posts
I've not had to clean any of my Heli bearings from dirt and grime, but I used an RPM bearing blaster ( RPM #81170 ).
It was used primarily to clean 5x11x4 wheel bearings in my Trucks and buggies, but i'm sure it would be great for smaller heli ballraces.
They're only about a fiver ($8) and are handy to have.
With regards replacement bearings; I buy mine from rcbearings over here in the UK.
I've found them to be cheap and of better quality and UBEC (Tolerance) than most stock bearings (particularly Walkera and Traxxas ones).
BTW.. I use the Triflow needle point pen dispenser as it's good for those hard to reach parts in our sub micro heli's.
Username> is offline Find More Posts by Username>
Last edited by Username>; Mar 10, 2012 at 11:08 PM.
Reply With Quote  (Disabled)