View Single Post
Old Mar 09, 2012, 09:41 AM
jackerbes is offline
Find More Posts by jackerbes
Jack
USA, ME, Ellsworth
Joined May 2008
18,083 Posts
Try using a plastic stylus sanded to a chisel tip or a similar not sharp tool to pop the remnants of epoxy free from the green coating. It takes a little time but I've always been able to get them off and leave the coating intact if it was not damaged.

It is so much harder to have to re-insulate a stator that any efforts that will leave the original coating undamaged is worth the effort.

Trying to remove it to get more room for wire would not be a good idea and the room gained would be hardly anything at all.

Jack
jackerbes is offline Find More Posts by jackerbes
Reply With Quote