View Single Post
Old Mar 09, 2012, 12:28 AM
spaaarky21 is offline
Find More Posts by spaaarky21
Helicopter Baron
spaaarky21's Avatar
United States, CO, Golden
Joined Feb 2012
66 Posts
Quote:
Originally Posted by seeingeyegod View Post
yeah TINY screws.. not sure i have anything small enough to unscrew them. Oh wait, just realized I was looking at the screw end not the head! Took off the servo from the wing and I think I can get them out. The servo managed to recenter itself, but it will only move if i give the gear a little roll by hand, then it loudly wretches into position, like something is binding in there.
If you haven't already, take the servo assembly off of the PCB. See if the gear and shaft rotate freely when it's not pressed against the board. Give everything a good cleaning and re-assemble it. If it still isn't moving well, I've seen the servo assembly sold separately at my local hobby shop. You could replace that part by itself, or if it's a stand-alone servo (not the integrated servos on the all-in-one board,) replacing the whole thing might save you some headache for a couple dollars more.
spaaarky21 is offline Find More Posts by spaaarky21
Reply With Quote