View Single Post
Old Mar 08, 2012, 11:50 PM
seeingeyegod is online now
Find More Posts by seeingeyegod
Registered User
seeingeyegod's Avatar
United States, OR, Portland
Joined Jan 2008
2,126 Posts
Quote:
Originally Posted by tracknoob View Post
It's probably worth it to disassemble the white worm gear part from the main servo PCB (a couple of tiny screws) then that will lift out and away, and you can check both the carbon track, as well as the silver fingers before you finally give up on it. It could be the silver sliders are bent and not making good contact.
yeah TINY screws.. not sure i have anything small enough to unscrew them. Oh wait, just realized I was looking at the screw end not the head! Took off the servo from the wing and I think I can get them out. The servo managed to recenter itself, but it will only move if i give the gear a little roll by hand, then it loudly wretches into position, like something is binding in there.
seeingeyegod is online now Find More Posts by seeingeyegod
Last edited by seeingeyegod; Mar 09, 2012 at 12:08 AM.
Reply With Quote