View Single Post
Old Feb 29, 2012, 12:49 AM
sg1anubis is offline
Find More Posts by sg1anubis
Registered User
sg1anubis's Avatar
United States, AZ, Scottsdale
Joined Sep 2011
544 Posts
Check that your transmitter and reciever are properly bound. Once the battery is connected you must army the board by applying full right yaw at zero throttle. If the led does not light in response to arming then you may need to adjust the trim and end points of your radio so that it recognizes that the throttle channel has a pulse between 1000-1100 micro seconds and the rudder between 1900-2000. It could also be that your channels have been reversed or the connections between your kk board and the reciever are incorrect.

Another thing I noticed is that you state you are using a mode 1 transmitter, therefore, the arming procedure may be different than the standard mode 2 transmitter.
sg1anubis is offline Find More Posts by sg1anubis
Reply With Quote