View Single Post
Old Feb 28, 2012, 10:36 PM
ZippoZ is offline
Find More Posts by ZippoZ
Registered User
Melbourne, Australia
Joined Apr 2008
14 Posts
Question
Skyartec 705 Buddy / Trainer setup

I have two Tx705 transmitters and would like to couple them together in a Master / Student configuration.

I have two issues:

1. What sort of cable do I need to couple the controllers together? Does anyone have a pinout diagram?

2. Using the SKY705_V2 software I have configured the two transmitters as per instructions, as Master and Student with the s/n as required. Not having a cable, I turned on the Master controller by itself and found that it no longer communicates with the Rx. Is this because it is not coupled to the Student Controller?

Any advice on how to use the Trainer mode would be appreciated.

Thanks
ZippoZ is offline Find More Posts by ZippoZ
Reply With Quote