Thread: Discussion Handy building tips
View Single Post
Old Feb 27, 2012, 11:49 AM
dedStik is offline
Find More Posts by dedStik
Redacted per NSA "suggestion"
dedStik's Avatar
United States, VA, Virginia Beach
Joined Feb 2012
5,513 Posts
Quote:
Originally Posted by Dad_Roman View Post
Garage sales

Twist it up on the handle, put a rubberband around it and spin it as needed.
Thanks for that idea. I was about to make a LHS run today to pick up more socks, will be stopping by the Thrift store instead.

Quote:
Originally Posted by bugerdup View Post
what is the best material for a building board? I have been using pine ready made panels from home depot. they are not bad, I use clamps to hold them true to the work bench. any idea's.
I use hollow core doors that you can buy from home depot or some such. They tend to be fairly level and they are large enough to set a model onto. Also the hollow core allows for t-pin usage.

Also decent advice when building, sometimes just walk away. Come back to it later.

EDIT: I went to the thrift store and bought some baby socks. They are the worst, I should have gotten the full dress socks as mentioned in the post. I got some that were close, they seem to be wearing out faster than an actual iron sock. The bright side is I essentially got 4 of them for what 1 iron sock costs.
dedStik is offline Find More Posts by dedStik
Last edited by dedStik; Feb 27, 2012 at 09:51 PM.
Reply With Quote