Thread: Build Log SebArt Pilatus PC-21
View Single Post
Old Feb 25, 2012, 02:49 PM
Rat Brother 1 is offline
Find More Posts by Rat Brother 1
Registered User
Rat Brother 1's Avatar
United States, AZ, Phoenix
Joined Jun 2011
187 Posts
Nosegear Install - continued

After much trial and error I feel that I'm nearing completion on this phase of the build

Before testing your servo to steering arm connection I strongly suggest that you set up a mix for the nosegear servo. This will cut power to the servo when the landing gear is up. Set up as follows.

I'm using a Spektrum DX7s transmitter.

Mix 1
RUD > AX2
Rate: 100%
100%
Offset: 0%
Trim: Inh
Sw: Gear0
Rat Brother 1 is offline Find More Posts by Rat Brother 1
Last edited by Rat Brother 1; Feb 26, 2012 at 03:54 PM.
Reply With Quote