View Single Post
Old Feb 25, 2012, 11:24 AM
davebloomer is offline
Find More Posts by davebloomer
Fly Low, Fly 3d, Repair Often
davebloomer's Avatar
United States, OK, Weatherford
Joined Jun 2011
2,735 Posts
Quote:
Originally Posted by turnerm View Post
Oh, OK. So I don't use the heat to get the surface ready for bending?? I just bend it cold and then use the heat gun to iron the wrinkles out?
yeah you are trying to shrink the ultrakote so it will hold the wood straight. Do it in small bits so you do have to go back the other way The covering is so strong its crazy. It is like 1 billion percent of the strength of an airplane i believe.
davebloomer is offline Find More Posts by davebloomer
Reply With Quote