: New Product
Hobbyking SLICK 3D 1.3M Really Official Build Thread
View Single Post
Feb 22, 2012
, 12:07 PM
Joined Feb 2011
Michael Wargo's Hobbyking Slick setup
Here some picture of my built and setup.
Motor- NTM Prop Drive 42-38 750kv
ESC-Turnigy Plush 60 amps
Servos- 2 Turnigy TGY-2216 mg (elev. & rudd)
Servos- 2 HK 929 MG digital (aile)
4 servos arms extensions (carbon fiber)
View all Images in thread
Factory motor mount holes.
This is the little modification to the motor mount.
never forget the loc tide on motor screws
Cowlin guides helps for perfect fitting.
the picture came upside down. you can see the rudd and elev at 90 degrees. Also the wing carbon fiber rod straight level with the elevator.
After install ailerons, rudder and elevator i always use hinge tape to cover the gap between. this can create vibration while you are flying.
More hinge tape
And the final Product.
Last edited by MrRican; Feb 23, 2012 at