Thread: Discussion DragonOSD+V2 with RTH
View Single Post
Old Feb 16, 2012, 03:16 AM
ultrojo is offline
Find More Posts by ultrojo
Registered User
ultrojo's Avatar
Malaysia, Johor, Johor Bahru
Joined Feb 2012
116 Posts
Hi DOSD+ support,

after too many try & error, i am stuck
Sorry , i have to ask you, about my new DOSD+v2

using:
flysky 9ch (upgrade er9x firmware)
rmile PPM encoder
DOSD v2
cam, vtx,vrxm gps

my DOSD+ can display parameter Volt,gps etc but cannot access control mode in chanel5 via Radiolink, i already setup ch5 for control mode. and screen appear "AP DISABLED" blinking always.

my servo attached DOSD+ can works.
but seems ch5 not work on DOSD. because 3switch i push seems not works. i try 2 radiolink also same

can help me to solve it
thanks
ultrojo is offline Find More Posts by ultrojo
Reply With Quote