Thread: Discussion BUSA N17 1/6 Build
View Single Post
Old Feb 14, 2012, 09:43 PM
Thermalin is offline
Find More Posts by Thermalin
I'm a pilot... 100 yrs to late
Thermalin's Avatar
USA, FL, Palm Harbor
Joined Jan 2005
3,831 Posts
I picked up some circuit board without the brass overlay tonight at Radio Shack. It was 3.19 for for 6x8. I think I should have picked up the one with the brass facing as this would have allowed soldering a tube to each side as a bearing. As is though I'm going to stick with what I have and make a sandwich type setup for the control arms inside the fuse per the pic. The holes which are much sharper cut than the pic shows, I will be able to laminate both sides with strips of wood, the expoxy will bind both sides through the holes for the first layer. I'll see how it comes out. I plan on using this for the elevators and rudder too with just a single laminate on each side. I hope to be able to stain the horns
Thermalin is offline Find More Posts by Thermalin
Reply With Quote