Thread: Discussion BUSA N17 1/6 Build
View Single Post
Old Feb 06, 2012, 05:24 PM
Thermalin is offline
Find More Posts by Thermalin
I'm a pilot... 100 yrs to late
Thermalin's Avatar
USA, FL, Palm Harbor
Joined Jan 2005
3,831 Posts
Engine valve cover is back together and so far so good.. no oil leak. Going to work on the other V-strut. I think I may stain and seal them when the time comes which would look nice. Don't see that on models usually.

Udpates:
I posted a question on RCSB for advice on the pull pull setup in terms of the support and creation of the bellcranks. Plan to have one for rudder and elevator. Something else I'm toying with is though the aileron servos will be in the wings...

I'm looking into having the aileron actuators near wing center operational in a faux fashion. Long thin-ish wire connecting aileron to the actuator to get up and down movement with vertical rods down into fuse to complete the "illusion".
Thermalin is offline Find More Posts by Thermalin
Last edited by Thermalin; Feb 07, 2012 at 11:53 AM.
Reply With Quote