Thread: Build Log Polaris Seaplane Parkflyer
View Single Post
Old Feb 02, 2012, 08:55 PM
wheelspinner20 is offline
Find More Posts by wheelspinner20
Registered User
wheelspinner20's Avatar
S.E.Michigan
Joined Jul 2010
2,240 Posts
Lenny, let me give you a little tip, I've done a couple nose jobs.!

when you cut the new stuff, make it longer than you need it toward the back, cut the side fuse pieces long enough to use 3 or 4 inches ( or more) of the main wing slot (even though you are going to cut that part off of the new pieces later). This alligns the nose section perfectly in line with the rest of the existing plane.

Cut the fuse somewhat straight where you are going to join the new pieces first, then slide the new ones on over the wing, pressing it onto the old fuse straight cut, then trace a perfect matching trace/cut line on the new piece one side at a time. Makes a really good fit.!

If you already knew this, maybe someone else reading this didnt.

Pat
wheelspinner20 is offline Find More Posts by wheelspinner20
Reply With Quote