Thread: Discussion Stator insulation & Epoxy
View Single Post
Old Feb 01, 2012, 12:26 PM
modisc is offline
Find More Posts by modisc
Inspiration
modisc's Avatar
United States, MI, Ann Arbor
Joined Aug 2011
895 Posts
Quote:
Originally Posted by martin_ View Post
Ya, I had seen your post about the accoustic test.

In fact my motor is an Hyperion 4035-500 12n10p, same as the HKIII.

I have the SK-720 with vibration logger, I will make a quick test running the motor only to see if vib have increased, I changed the main shaft too for a longer one.
I see, hyperion motor is nearly identical to scorpion ^^. My original scorpion 40xx, both 4035 and 3 4025, all have perfect test run with no vibration felt with bare hand. I rewinded all except one of the 4035, and only the 4035 gives greater vibration during the test run after a rewind and shaft , bearing replacement. So i must have screwed up something, and i am still trying to figure out the problem. Also i am having a hard time to rebalance the 4035

Does the SK-720 help to rebalance the bell (to determine where to add or cut weight on the bell) or it can only be used to test vibration level?
modisc is offline Find More Posts by modisc
Reply With Quote