View Single Post
Old Feb 01, 2012, 08:27 AM
samc99us is online now
Find More Posts by samc99us
Aurora Builder
United States, MD, Lusby
Joined Nov 2003
4,067 Posts
Russ,

There are known issues with that board (http://www.cnczone.com/forums/steppe...per_motor.html). While inexpensive, I suspect you may run into issues for 24/7 use.

If you decide to go for a different board, and you don't want to solder up one, I don't mind building another hobbycnc board (takes about 4 hours and a steady, steady hand). That is what I am using. Personally though, for a router, I would get a Gecko 540 and call it a day: http://www.cncrouterparts.com/gecko-...rive-p-40.html
samc99us is online now Find More Posts by samc99us
Reply With Quote