View Single Post
Old Feb 01, 2012, 06:07 AM
Prof100 is offline
Find More Posts by Prof100
Registered User
Prof100's Avatar
Canton, Michigan USA
Joined Jul 2007
16,807 Posts
Quote:
Originally Posted by Dkumagai View Post
I think I'm going to go ahead and buy a microdan motor. However, I got to thinking and I'm wondering how the hell I'm going to mount it to the v4 motor mount. I would just use that aluminum mount on his site, but there wouldn't be any way to affix it to the v4 plywood mount. I'm thinking about using a 1 inch wooden dowel to fashion an adapter, but I'm not sure. Any ideas?
There is a whole page of motor mounts on Dan's website. http://www.gobrushless.com/shop/inde...f=MOTOR+MOUNTS


I would ask him for suggestions. Perhaps send him a picture of the V4.
Prof100 is offline Find More Posts by Prof100
Reply With Quote