Thread: Discussion school project
View Single Post
Old Feb 01, 2012, 04:49 AM
rangamatchstic is offline
Find More Posts by rangamatchstic
Registered User
Mt helena western australia
Joined May 2009
2,013 Posts
Discussion
school project

My goal is to make a plane retreivial system that turns on when the receiver loses power or signal and it uses gyros to level out an rc plane then turn it 180 degrees in a gentle slow turning bank aswell as turn, then it has to fly level after the turn, fly for about a quarter of the total time you have been flying for then slow down until it stall s and deploy a parachute. My only problem im going to have (i have looked into all the other components and found ways to do them using components available to me) is i want a single signal wire to be attached to the servo signal wire at all times to control the servos when the planes receiver loses signal. What i am wondering about is A. will the receiver lock the servos in place if it losses signal and can you change this setting if so, and B will the receiver be ok when a signal is given to the servo on the same wire ie will this short the receiver out.
rangamatchstic is offline Find More Posts by rangamatchstic
Reply With Quote