Thread: Discussion Stator insulation & Epoxy
View Single Post
Old Feb 01, 2012, 12:42 AM
modisc is offline
Find More Posts by modisc
Inspiration
modisc's Avatar
United States, MI, Ann Arbor
Joined Aug 2011
895 Posts
Quote:
Originally Posted by martin_ View Post
Yes, it have 5.5 turn, I found it strange.

For now I rewind it in parallel and use ''YY'', which is different than the original delta terminating.

http://translate.googleusercontent.c...1M8H-6u4WKZj0A

Out of curiosity, have you measured your KV with a drill press, multimeter and tach?
I use another way to measure the Kv, which is accurate enough for me. I test my original scorpion's Kv with this acoustic method, and it is a good match with the labelled Kv. You can try it if you are interested. Here is a thread I posted: http://www.rcgroups.com/forums/showthread.php?t=1559695

So your's 4035 is the newer HKIII 12N10P. It will be nice to try the YYwinding, which will make single thick wire winding much easier. Good luck.

When I disassemble my 4035 and replaced with a new shaft, it seems that I may have broke the balance of the bell, as i noticed some vibrations when the reassembled motor (rewinded) is tested to about 25,000 rpm speed. Be careful.
modisc is offline Find More Posts by modisc
Reply With Quote