Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Jan 31, 2012, 08:14 PM
mr.incredible is offline
Find More Posts by mr.incredible
An ordinary sort of incredible
mr.incredible's Avatar
United States, TN, Knoxville
Joined Dec 2004
932 Posts
Originally Posted by NICO38 View Post

ok on the site page of I must connect ESC for make power on my Crius board.
Is there exactly ?
Because on this thread it is indicate that is the power for Crius com from the RX receiver
But i don't know how i can make power on my rx receiver

Many thanks,

Power for the RX and the Crius board comes from the servo connector off of one of the ESCs. Only one of the 4 power connections (red) should really be connected to the Crius at a time. You can release/pull the red pin out of the connector and tape or heat shrink it back on itself. As with any MWC more than one power source can cause conflicts.

***Oops! looks like I just randomly answered a really old post... LOL Sorry...
mr.incredible is offline Find More Posts by mr.incredible
Last edited by mr.incredible; Jan 31, 2012 at 08:19 PM.
Reply With Quote