View Single Post
Old Jan 28, 2012, 04:28 PM
John_NZ is offline
Find More Posts by John_NZ
Registered User
New Zealand, Taranaki, New Plymouth
Joined Jan 2012
333 Posts
Quote:
Originally Posted by dodgeboy222 View Post
same thing. says access violation at address 5003EAEE in module RTL160.bpl.
write of address
Just to double check, if you start the program from fresh and then go to the setup screen without pressing connect, you get the access violation?
Does it do the same after you reboot your computer?

@Been Flying, version 1.14 fixes the centering problem. I also had 1.13 for download when the site said 1.12 was the testing version, that may have caused some confusion.

I will put version 1.14 up now and shift 1.13 over to stable. 1.14 introduces queuing of the messages to the gyro to make sure that each configuration message sent to the gyro is acknowledged. I had not been taking advantage of the full protocol to date, so have changed it to do that.
The status bar shows the number of queued messages. It typically should only show 0 or 1 messages. If it shows more than 1, it will change to red to indicate some comms issue. I haven't given it much testing, so let me know if it gives any issues.

I have also made the com indicators show activity while it is scanning and when it receives data from the gyro (3rd light flashes).
John_NZ is offline Find More Posts by John_NZ
Reply With Quote