Thread: Discussion RadJet from the KING!
View Single Post
Old Jan 28, 2012, 11:34 AM
captaingeek is offline
Find More Posts by captaingeek
master of the universe
captaingeek's Avatar
USA, CA, Novato
Joined Jul 2008
3,076 Posts
Quote:
Originally Posted by vettster View Post
The stock CG is 383mm from the nose down the center line of the fuse. You need to add 15mm so it will be 398mm from the nose. Round it off to 400mm and you will be fine

My Turangy motor showed up today
Thanks. Tried to maiden yesterday. Took off facing the wind and gained some altitude. Turned to make a downwinpass and figured I could cut it back to 50% throttle. Tried to cut back into the wind to make a pass flying into the wind. Made my turn but was loosing altitude fast and could pull back up

I crashed and luckily only knocked one of the wings loose and minor damages. Im glad I used PU glue as it holds to this foam well but allowed the wing to pop out of its sockets. I think if I used hot melt or CA glue it would have broken the wing.

WIll lower the roll rates and try again.
captaingeek is offline Find More Posts by captaingeek
Reply With Quote