View Single Post
Old Jan 28, 2012, 03:54 AM
Hardtail is offline
Find More Posts by Hardtail
Registered User
Joined Mar 2010
2 Posts
I just built my 1400mm Stuka and everything went fine, but when I was mounting the prop blades I could only thread one screw (the inner most) in each blade. The outer hole in each blade doesn't seem to be open all the way through the base of the blade. Is the idea to simple thread the screw through the plastic? Drill it out? Are two screws necessary? It would seem so, but I'm just not sure and would like a little direction before I proceed.

Thanks,
Dave
Hardtail is offline Find More Posts by Hardtail
Reply With Quote