View Single Post
Old Jan 24, 2012, 08:50 PM
John_NZ is offline
Find More Posts by John_NZ
Registered User
New Zealand, Taranaki, New Plymouth
Joined Jan 2012
333 Posts
Quote:
Originally Posted by 2Doggs View Post
It's happening when I go directly to the "Servo Trim" window from the "Setup" window - but only without the controller connected. So it prevents me being able to use the software to edit the .ini file, but there is no problem with the controller connected.
What are your steps to see the problem?

1. No Controller connected
2. Load an ini file (swash plate type?)
3. Open setup window
4. Click servo trim tab
5. Click any chevron

Then you see ch3 go to 125?

Is this correct?
John_NZ is offline Find More Posts by John_NZ
Last edited by John_NZ; Jan 24, 2012 at 10:35 PM.
Reply With Quote