View Single Post
Old Jan 22, 2012, 11:18 AM
3drcparts is offline
Find More Posts by 3drcparts
inverted-i-fly
3drcparts's Avatar
United States, CA, Petaluma
Joined Mar 2011
4,541 Posts
Quote:
Originally Posted by cwojcik View Post
I've had dental floss pull out after a while. It works better than nothing but after a few good tugs or lots of use it will separate from the glue.

The best hinge preserving method I've found is to cut a 1" square piece of Blenderm tape and put a coating of welder's on the sticky side, then put that at the end of the hinge. The adhesive in Blenderm won't stick to EPP, hence the welder's.
I have torn the welders hinges on my 3dhs foamies so many times that I now just use blenderm on top of the welders, stick fine on dried welders so I will do the same here on the corners
3drcparts is offline Find More Posts by 3drcparts
Reply With Quote