View Single Post
Old Jan 22, 2012, 10:44 AM
scoby1 is offline
Find More Posts by scoby1
Registered User
British Columbia, Canada
Joined Jul 2009
296 Posts
Quote:
Originally Posted by jaccies View Post
so the red led is only on now i presume.
did you had to reverse channels like rudder?
try below that sequence

when i arm the board i need to do this:
- power on
- full throttle, right ( or left) rudder ( led flash one time) ,
- throttle minimum , right ( or left) rudder ( led flash one time and stays off ) board is armed now , only red led is on.

When with throttle low i put rudder left (or right) ,led flashes one time and board will disarm , and again with throttle low i put rudder right (or left) led flashes one time it will arm board again.

FYI if throttle level is lower then 20% and you give rudder left( or right), board will disarm !!
Thanks,got it ....after playing around with this sequence I managed to get the board to arm now for a test flight.
scoby1 is offline Find More Posts by scoby1
Reply With Quote