View Single Post
Old Jan 21, 2012, 02:19 PM
pug398 is offline
Find More Posts by pug398
Registered User
VA
Joined Nov 2009
2,742 Posts
Simon I have been using the 12/31 bs firmware on 6A esc and overall they perform ok but wondering if you had an idea about small problem. If you slowly raise throttle say to lift off rpm they then track throttle no problem smooth response through out range. If you go from off state immediately to 1/3 to 1/2 throttle they unsync. If you lay finger against bell and slowly apply throttle they unsync. Once free spinning they never seem to have a problem and do fine. Any ideas?
pug398 is offline Find More Posts by pug398
Reply With Quote