Thread: Build Log Build: Birdofplay 62" Flyguy
View Single Post
Old Jan 20, 2012, 06:27 PM
Otto Dieffenbach is offline
Find More Posts by Otto Dieffenbach
United States, CA, San Diego
Joined Aug 2011
2,888 Posts
Step 13

First I marked the location of the inch wide 5mm plywood lateral motor support. I located it over the first Depron tab. The support should span side to side and replace the front of the first tab. I lay the motor on the Depron with the plywood motor mount against the lateral support location and locate where the prop slot and motor cutout will be. I then make appropriate cuts and glue the Depron and support pieces in place with Gorilla Glue.
Otto Dieffenbach is offline Find More Posts by Otto Dieffenbach
Last edited by Otto Dieffenbach; Jan 20, 2012 at 09:15 PM. Reason: grammar
Reply With Quote