View Single Post
Old Jan 19, 2012, 09:51 AM
lhb009 is offline
Find More Posts by lhb009
Crash Pilot
USA, UT, Provo
Joined Oct 2010
24 Posts
New to EDF

I am in the process of building a 5' EDF flying wing(EPP foam). I have built about 30 pusher flying wings, but I have never built or flown EDF models. What key differences would you point out? In addition to my flying wings I have built, more than a dozen balsa buildup, gas/Electric/sailplanes.

I plan to make it 5' span, weigh less than 4 lb, dual EDF units on the top rear where the prop normally would be. How big of EDF units should I start with? I was considering 60-90mm units. I will be flying it with a DX6i, with HS 82mg servos. Is there anything else I should know prior to buying electronics?
lhb009 is offline Find More Posts by lhb009
Reply With Quote