View Single Post
Old Jan 17, 2012, 09:08 PM
Mmarshall is offline
Find More Posts by Mmarshall
Hey... watch this...
Mmarshall's Avatar
Herndon, Virginia, United States
Joined Feb 2003
787 Posts
Well pulled the servo apart, wire to motor was broke off probably when it was assembled...solder was OK must of caught during assembly and was hanging on by threads (literally) so it worked for a few seconds.

5 Min fix with some new solder... Elevator servos actually do not look to bad in quality... close to an HS65MG.

V8 how is the roll rate?

I was thinking differential TV for elevator to help in high alpha... that would mean just Y the rudder to the TV.

Next up pull the fans and balance.

Also V8 my motors are the same as Mray... looks like you are the odd man out..
Mmarshall is offline Find More Posts by Mmarshall
Reply With Quote