Thread: Discussion Fy-31ap
View Single Post
Old Jan 17, 2012, 02:32 PM
simplyfly is offline
Find More Posts by simplyfly
go ahead and try
Canada, ON, Maynooth
Joined Nov 2011
521 Posts
What I have so far... Perhaps a properly wired example could be shown here... I hope the photo helps. The connection from the Rx to the FY-31 is obvious. The connection to the GPS I think is correct. The current sensor, shown with the ESC and supply battery make sense... The three control servos are correctly connected I am sure. The OSD receives power via the 1300Ma shown to the left, which also powers the Vid Tx and camera.

The Vid in and out is a little unclear to me... The Vid in and Vid out makes sense, but the corresponding pins do not seem to fit a standard two pin connection. It seems that the connection is made across the two top pins, horizontally, yet the key on the top of the unit suggests that the connection is made vertically, which is where the problem with the two pin connector is.

I hope that someone more familiar with the "correct" way to set this system up will post a response...
simplyfly is offline Find More Posts by simplyfly
Reply With Quote