View Single Post
Old Jan 14, 2012, 07:58 PM
jesolins is offline
Find More Posts by jesolins
Tri-Quad-Hexa-Octo-copters!!
United States, TX, San Antonio
Joined Feb 2007
15,134 Posts
J,
OK. Make sure you have a Tx channel on the FF ch 6 to set the 3d mode/self-leveling on and off. However if it is left off it does the self-leveling.
Cheers,
Jim
Quadrocopter and Tricopter Mega Link Index
Quote:
Originally Posted by Julkabas View Post
oops again.. i did not disconnected physically the CH5. Just flipped the CH5 switch off. i'll try to disconnect it...

The quad came ARTF from GLB and was "prewired" with the 20A esc's and motors connected to a power distri board, so i assumed the esc's where set.

Flat battery now, so i can not test before it's charged
i try your suggested esc setting tomorrow.

that megaindex is a goldmine! never took the time to scroll to the first post on page 4 ; there is all the info!! (stupid me)

have to go to bed now.
thx a lot guy's
jesolins is offline Find More Posts by jesolins
Reply With Quote