Thread: Discussion DragonOSD+V2 with RTH
View Single Post
Old Jan 11, 2012, 04:07 PM
Vantasstic is online now
Find More Posts by Vantasstic
'FPV'er...not a "LOS'er
Vantasstic's Avatar
Las Vegas, NV
Joined Sep 2003
19,518 Posts
Quote:
Originally Posted by crazy1pilot View Post
alright i recived my DOSD programmer... but im lost. i have read the section in the manual about connecting to PC. but it doesnt say what goes where...

DOSD has:

TX
RX
GND
3V3
MCLR

programmer has:

RST
3V3
5V
TXD
RXD
GND

im assuming that it goes like this?

DOSD-USB
TX - TXD
RX - RXD
GND - GND
3V3 - 3V3
MCLR - RST?

is this the right connections?

i just have a fear of damaging something
You ONLY want to connect three wires, Gnd, Tx, and Rx. You also need to power the DOSD via either the Current sensor w/jumper or a 5v+ battery on the DOSD power pins. Take a look at pages 80-81 of the DOSD V2 manual...it show's the required connections.
Vantasstic is online now Find More Posts by Vantasstic
Last edited by Vantasstic; Jan 11, 2012 at 04:15 PM.
Reply With Quote