View Single Post
Old Jan 11, 2012, 01:22 AM
nenno is offline
Find More Posts by nenno
Registered User
Joined Jan 2011
17 Posts
Quote:
Originally Posted by nenno View Post
Hallo...

... my DIY module dosn't work together with my blade MCPX V2.
I use the TX-Modul of a MLP4DSM. The problem:

- I bind the Blade
- Blade stops to flicker blue (looks good so far)
- As soon as I release the bindbutton of my DIY module, the engine starts to run (luckily not at full throttle)
- The engine is running about 5-10sec. - Then the helicopter flashing blue

I use the module on my MX16-Hott. I adjusted the channel order in the sketch ([6,2,3,4,5,1]).
My DIY-Modul works great with a blade MCPX V1!!

For useful tips I would be grateful ...

Nenno
Hello...

I've solved the Problem. I've build now the module following the instructions of mha. I've flashed Version 2 of mha's modded software.
The Blade MCPX V2 binds now to my module.
I can now press the yaw stick to the right and the blade V2 binds now in Compter-Mode!

Thanks to mha...

Link to mha's modded Software V2:
http://www.rc-heli-fan.org/viewtopic...29741#p1329741
nenno is offline Find More Posts by nenno
Reply With Quote