View Single Post
Old Jan 08, 2012, 12:34 PM
m_beeson is offline
Find More Posts by m_beeson
FPV junkie
m_beeson's Avatar
United States, UT
Joined Jan 2011
3,603 Posts
Dadude,

I would also check to make sure that you don't have a bad connection /or broken wires to the camera.

You can pull power and ground from the plug, and see that you are getting 12v.

and you can check resistance across the signal wire.




also this is probably not an issue, but check to make sure that your Vtx and Vrx are on the same channel.


if you are using EE, then make sure that your input matches the Vrx input that you are using.


-Mike
m_beeson is offline Find More Posts by m_beeson
Reply With Quote