View Single Post
Old Jan 08, 2012, 11:46 AM
Dadude is offline
Find More Posts by Dadude
Nothing but high quality
Dadude's Avatar
United States, CT, Glastonbury
Joined Jun 2008
747 Posts
It's my castle BEC . I just tested it. It simply outputs the voltage of the pack and doesn't step it down out all! That means my OSD, all my servos, and my rx, were submitted to 12volts.....If the sensors are powered off the OSD then those may have received 12 volts as well. This is bad....is my stuff shot? I really didn't expect this from castle I have only had good luck with them in the past.

Jon
Dadude is offline Find More Posts by Dadude
Last edited by Dadude; Jan 08, 2012 at 12:19 PM.
Reply With Quote