View Single Post
Old Jan 08, 2012, 09:13 AM
jkettu is offline
Find More Posts by jkettu
Registered User
Joensuu, Finland
Joined Mar 2002
1,748 Posts
Connect the 4.8V bec and those servos you want to run at 4.8V directly to the receiver, just as you would if the whole system was run at 4.8V.

On those servos you want to run at 6V, cut the positive power wire. Connect the signal and ground wires to the receiver as usual.

Connect 6V bec positive output to the positive servo power wire(s) which you cut in the previous step. On the servo side of the cut! Don't let the 6V power get into the 4.8V side.

Connect both esc grounds together. Done.
jkettu is offline Find More Posts by jkettu
Reply With Quote