View Single Post
Old Jan 05, 2012, 07:06 PM
bytemuncher is offline
Find More Posts by bytemuncher
Registered User
Tokyo
Joined Jan 2010
700 Posts
Quote:
Originally Posted by SadSack View Post
servos are fine for GCP but do have mod them.
Problem is as farmer said pwm from rx is inverted. I used 2N7002 does the trick but swapping motor and pot wires around lot nicer if your happy with soldering that small area.
I will add when i swapped wires around 2 had red wires from centre of pot but one was all black.
I was aware that was an issue with the HK-5320's, but thought the hk-282a's were supposed to be somewhat plug-in-play-ish...just requiring the negative and signal wire to be swapped on the outside and not requiring internal rewiring/soldering.
bytemuncher is offline Find More Posts by bytemuncher
Reply With Quote