View Single Post
Old Jan 05, 2012, 05:44 PM
sotog is offline
Find More Posts by sotog
Trader Rating: 22
sotog's Avatar
United States, CA, Santa Barbara
Joined Nov 2009
671 Posts
Trader Rating: 22
I see what you are looking for. This is a great idea.

To keep things simple, I could come up with the exact same shape as the flange on the tube, but make it a solid flat piece that would be .125" thick to accommodate the 4 tapped holes (same thickness as the flange). I could then machine a small slot in the flat plate for the motor shaft at the different heights for those style motors that need it.

This is something I can definitely do with minimal new design and setup time since it would be using the same work holding I already have.

I'll put a drawing together and see what you think. I'll send you a PM so we can continue this conversation.

Thanks,

Terry
sotog is offline Find More Posts by sotog
Site Sponsor