View Single Post
Old Dec 30, 2011, 08:22 AM
Jessestr is offline
Find More Posts by Jessestr
Registered User
BelgiŽ, Vlaams Gewest, Evergem
Joined Nov 2011
738 Posts
Quote:
Originally Posted by quadraf View Post
What i can see in your picture is that in your case pin 2 is VCC ( first not connected,because no connection). pin 7&8 are GND pins so you may connect 1 or both!. The rest of the pin connections i cannot see in your picture...
I gues you have it connected correctly because you say it worked in 1.8p2. In 1.9 there is no difference in schematic. Maybe a wire got loose, check your solderings...
Hans
Thanks ! Stupid they didn't put it on the diagram.. It's confusing if you don't know it.

I'm getting lots and lots of errors in debug2 with 1.9, whats wrong? In 1.8p2 everything works... It's an original WM+
Jessestr is offline Find More Posts by Jessestr
Last edited by Jessestr; Dec 30, 2011 at 08:40 AM.
Reply With Quote