View Single Post
Old Dec 29, 2011, 07:04 PM
nasgul is offline
Find More Posts by nasgul
Registered User
nasgul's Avatar
United Kingdom, Wales, Gwaun-Cae-Gurwen
Joined Mar 2011
535 Posts
ok, managed to upload sketch to my flydumini, and get into gui ok. here's the question though...... when connected to gui, i can arm board and motors fine, however, when disconnected from gui, i plug lipo in, go to arm board (which it does) but esc's refuse to arm, and start beeping. it's like the flydumini forgets all settings? help?
nasgul is offline Find More Posts by nasgul
Reply With Quote