View Single Post
Old Dec 28, 2011, 05:30 PM
magomora is offline
Find More Posts by magomora
Registered User
Joined Dec 2011
21 Posts
Hello All

i am still struggling with the calibration of my flydumini, because i am not
so experienced with the MultiWii system and this is my first one. (with WMP+ and BMA020)
Because i have not much experience in flying in Acro mode i am not able to calibrate
the mini in Acro mode.
Like Goofy23 i tried to fly in Stable mode first.

My problem is that after each plugging a new full Lipo, the copter is several degrees
off horizontal level and i have to trim ACC again.
Doesn't the software store the settings from the flight before?
This is really nerve-wracking.
magomora is offline Find More Posts by magomora
Reply With Quote