Thread: New Product Fancy Foam MX2 by RJ Gritter
View Single Post
Old Dec 23, 2011, 05:41 PM
hpapilot is offline
Find More Posts by hpapilot
Oly crap.. Deese ease not gud!
hpapilot's Avatar
USA, NC, Kernersville
Joined Nov 2006
1,160 Posts
Definitely keep the weight down as much as possible then, and run 9" blades. The HS35 would probably work on vectoring, if you wanted to go that route, if it actually puts out that much torque. But my experience is all with 8" blades on lighter motors and airplanes... so it might be too much. For now, I'd suggest sticking with the coupled setup.

Best of luck, let us know how it works!

RJ
hpapilot is offline Find More Posts by hpapilot
Reply With Quote