Thread: Question Double horse 9116 Heli
View Single Post
Old Dec 23, 2011, 05:00 PM
stormforce is offline
Find More Posts by stormforce
Closed Account
Joined Nov 2011
1,246 Posts
Joescan, I'm not familiar with going into the settings yet, but this is exactly what I get, in sequence;

All stick trims are centered, throttle stick is at it's lowest position; rocker switch is in the 'quick" position.

Switch the TX on; the battery voltage indicator shows full and the actual voltage value flashes and fluctuates between 7.6vdc and 8.1vdc; the red LED flashes and the buzzer beeps quickly 14 times quickly, then changes to a higher pitch single beep and falls silent; red LED stops flashing.

-----------------------------------------------------

Long press of the MENU button; after 1 second the backlight glows;

MODE Flashes; 2 is visible

Press of the MENU button and ELEV SUB F flashes - 000 ("F" suddenly appears next to the RUDD TRI)

press of the SEL button, AILE SUB L flashes - 000
press of the SEL button, THRO SUB F flashes - 000
press of the SEL button, RUDD SUB L flashes - 000

press of the SEL button, back to ELEV SUB F flashes - 000

press of the MENU button, ELEV D/R - 100%

press of the SEL button, AILE D/R flashes - 100%
press of the SEL button, RUDD D/R flashes - 100%

press of the SEL button, back to ELEV D/R flashes - 100%

press of the MENU button, ELEV REV flashes - REV

press of the SEL button, AILE REV flashes - REV
press of the SEL button, THRO REV flashes - NOA
press of the SEL button, RUDD REV flashes - REV

press of the SEL button, back to ELEV REV flashes - REV

press of the MENU button, ELEV EPA flashes - 100% (RUDD TRI changes to F)

press of the SEL button, AILE EPA - 100% (RUDD TRI changes to A or R)
press of the SEL button, RUDD EPA - 100% (RUDD still at A or R)

press of the SEL button, back to ELEV EPA flashes - 100% (RUDD TRI changes back to F)

press of the MENU button, THRO TRI 0 - 000%

press of the SEL button, THRO TRI 1 - 000% (OR I, can't tell, probably 1)
press of the SEL button, THRO TRI 2 - 050%
press of the SEL button, THRO TRI 3 - 075%
press of the SEL button, THRO TRI 4 - 100%

press of the SEL button, back to THRO TRI 0 - 000%

press of the MENU button, back to mode - 2

END OF MENU

-----------------------------------------------------

That seems to be all I get without pressing the "up" & down" buttons which obviously changes the settings.

Mick.
stormforce is offline Find More Posts by stormforce
Last edited by stormforce; Dec 24, 2011 at 03:26 AM.