Thread: Discussion 2.4 Meter Horten VII
View Single Post
Old Dec 20, 2011, 04:40 PM
birdofplay is offline
Find More Posts by birdofplay
Registered User
birdofplay's Avatar
United States, IN, Indianapolis
Joined Dec 2005
9,513 Posts
I'm Back again today !

The Turtle Deck is Hogged and Finished in X & Y .
It's still gotalota sanding needed but the cold shop machine work is done.

Started at 10:15 with a short lunch break and it was done around 2:30.

It could have been much longer but I got creative with feed rates after
observing and making some corrections.

I did have to redo 1/2 the X finish pass Since I'd not taken into account
a ~.25" Bit Length Difference between the Hog off bit and the Finish bit. Duhhh !
I'm not a practiced machinist ! far from it.

Regardless check to pix.

L8r

Bob
birdofplay is offline Find More Posts by birdofplay
Reply With Quote